The place where i got the amp installed said that my oem unit cant be amped. So be certain you get your signal from the stock subwoofer if your vehicle comes equipped with one. If it does, that would indicate possibly a poor ground for the amplifier. Before you begin the installation process, it's imperative that you make sure the amp you've chosen is capable of accepting speaker or line-level connections. Hope to hear a response. One way to check this is try fading just to those speakers, than balance it left and right. As soon as the speakers were amped up the sound shuts off.
Savannah. i am brigitte from hungary.i am very sexy and sensuale. it takes more then just looks to be a good companion...i have the ability to make you feel at ease right away...you will find me to be a lady of class, who is elegant, yet still raw, cheeky, with the right amount of naughty and a whole lot of tease.
I have read that the amp also powers the door speakers.
Amp To Stereo Rca To Speaker Wiring Harness Factory Line
Installer thinks a remote turn on signal is feeding back from the amp. Anything like that? The reason for this is the stock amplifier will be crossed over at a certain frequency. I had this same system installed on a gmc sierra and was able to control the bass through the factory radio bass controls but nor sure why it doesnt control it on the jeep? I have installed a kit like you are talking about, it was 4 or 5 speaker wires that were spliced total. The best way to do this would be to use a processor that corrects the audio coming out of the head unit before it gets fed into the amp. Step 7 Hook up both the positive and negative cables to the amp and find a grounding point within range of the negative cable.